Wedding pillow with rose

A wedding in black and white is difficult to surprise anyone. Newlyweds strive to make their holiday not only unforgettable, but also unique. Therefore, more and more often the celebration is dedicated to any topic - sea, olive, birch. Young people with a special bright temperament make pink weddings in which red is everywhere, a symbol of fiery love and roses, indicating sensuality and tenderness. For a pink wedding, all accessories should be unusual. I want to clearly demonstrate to you how to create a pillow in red with a rose for offering wedding rings.
You will need a piece of red fabric 35 by 20 cm, thread, cotton, white ribbon, white mesh and satin wide (5 cm) ribbon to create a rose. For the petals, get some green ribbon. Use hot glue to hold the rose petals together. The rosette is made using the kanzashi technique, to create such petals, you can use tweezers and a lighter or a metal ruler with a soldering iron, you need glass to work with a hot soldering iron. When everyone has prepared, we will begin to create a pillow. Sew fabric on three sides.
Then fill it with cotton or other soft material. No need to stuff tightly, otherwise the rings will simply slide.
Sew the fourth side at the pillow.
Now we trim the edge of the pillow with a white satin ribbon. A width of 4 cm is suitable. Make slips through 4 cm by 2 cm.
You can pin the folds with pins, and then overcast
Sew the figure eight into the corner from the middle tape.
Cover the rest of the area with a net. It can be sewn or glued.
Let's create a rose. The mode is a tape of 50 squares, their size is 5 cm. You can cut either with a soldering iron or scissors, but with further fusion of the edges above the lighter.
Bend the square as in the picture.
Next, you need to bend one edge so that the corner is in the center of the lower side. Then bend the other edge in the same way.
To create a rose petal, you need to trim the base and solder all the layers, in the end we get these blanks:
We twist the first petal - this is a rose bud.
Next, glue the petals one after another in a spiral. Be sure to try to give the rose an even look, do not make the middle of the flower bulge or fall out.
The reverse side of the flower is glued in one plane.
Getting started creating green leaves. To do this, take the grass-colored ribbon and cut out with scissors the petals resembling the original roses.
Singe them over the flame, often bend. That is, they scorched 2 cm and bent their fingers.
Sheets should take a more voluminous appearance.
Preheat the knife and push the veins of leaves onto a towel.
Such leaves should turn out
Stick leaves to create a composition
Now glue the rose or sew it. Be sure to manually push the recess in the cotton in the middle of the pillow to put the rings there.

Watch the video: Diy Crochet Ring Bearer Rose Alternative For A Pillow (May 2024).