FLUFFY EARRINGS

Send

Most girls prefer jewelry made of precious metals, but by no means refuse jewelry from natural materials - stone, leather, fur. Earrings with stone beads and fur look stylish with almost any clothing. The technology of their manufacture is simple. Not only young people can cope with it, making original gifts for girls, but also women.
The following tool is useful for work:

ruler;
awl;
hairbrush;
pencil;
small pliers;
small pliers;
transparent glue "Moment-Crystal";
knife blade;
scissors.

The material used is:

fur of colored fox with long hair;
2 bowl-holders with a radius of 0.9 cm, a height of 1.6-2 cm;
4 bead bowls with a radius of 0.3 cm and a height of 0.8 cm;
2 stone beads in the color of fur with a radius of 0.7 cm;
shvemzy - 2;
pins - 4 3.5-4cm long;
threads under the fur.

Working process.
1. Take a piece of fur and prepare it for work.

Comb the skin, find the softest, unsurpassed part of the mezra, determine the direction of the pile. The hair on the skin in the earrings should go from top to bottom. Mark on the skin 2 rectangles 1.5x4-5cm. Blanks for earrings are cut with a blade on the side of the skin. The fur on the cut from the opposite side is fully extended. After cutting, the skin on the workpieces is scraped for evenness with a blade. Slices are scraped off with a blade.
2. Rectangles on the skin side are glued and tightly wound into rollers. Top roller is wrapped with thread. The thread is smeared with glue.

3. When the part dries, the roller is pierced vertically through with an awl.
4. A pin is inserted into the hole on the furry side. A holder cup with a radius of 0.9 cm is put on its tip.

For soft fillers (leather, fur, fabric, knitwear) it is better to use hard bowls.
5. The excess pin is chopped off by the cutting sidewall of the pliers.

The rest of the pin 0.5 cm long should come out of the bowl.
6. A ring with a connector is made on the tip of the stubby pin with pliers.

7. The second half of the earrings. On the pin, put on a holder cup with a radius of 0.3 cm, a bead and another same cup so that they wrap around the bead.

For hard filler (metal, stone), soft bowls are good, changing shape due to their openwork.
8. Cutting the sidewall with pliers must chop off the tip of the pin with a remainder of 0.5 cm.

9. Bend the ring with round pliers.

10. Using split rings, connect 2 parts with a bead and fur.

The result was a design with first mobility. Such earrings will fit better on the neck.
11. The fastener is attached to the structure using split rings.

They will give the earrings a second mobility.
12. If the skin is sensitive to base metals, it is better to use silver shvems.
13. For the strength of the rings on the earrings can be gently tightened.
14. Earrings with stone and fur are ready.