Original designer water filter lamp

Pin
Send
Share
Send

To make the interior of a room or living room truly stylish and unusual, it is not at all necessary to buy expensive branded accessories for this, the price of which sometimes reaches sky-high heights.

It is enough to show a little ingenuity and use the most ordinary things that are sold in almost any store and cost a penny. For example, an original designer lamp for a home can be made from a conventional water filter.

For this craft, you will need one filter, PVA glue, a rubber inflatable ball and a cover from a plastic bucket with a diameter of 25 mm.

The main stages of work

First of all, it is necessary to inflate a children's rubber ball so that it is about 40 cm in diameter. Then, a plastic bucket lid is attached from above using tape. Next, it will be necessary to wrap this "design" with packaging film.

The bottom of the bottle from the PVA glue must be pierced with an awl or something else, and through this hole (and then through the cap with the spout), pass the edge of the polypropylene thread of the water filter. Then glue diluted with water is poured into the bottle again.

Then you need to rewind the ball with a thread, so that in the end you get a peculiar such net "web". In time, this work takes about 30-60 minutes. But if the hand is not full, then it may take more time.

At the last stage of work, the rubber ball must be deflated and pulled out of the resulting lampshade. Well, then it remains only to install the cartridge with a light bulb. For more information on how to make an original design lamp for the home from a water filter, see the video on the site.

Pin
Send
Share
Send

Watch the video: UV Lamp in water purifiers explained. (March 2024).